Turning Archive 2005

Subject:
turning a cube? *PIC*

Keith Tompkins
>Thought I would post a photo of a cube being turned. first I turn between centers, then a jam chuck to finish off. In the photo, the tailstock is in place for security, then will be removed to finish the very center of that side. In the photo, you can see the cube has been hollowed and a threaded ebony insert installed.

Yes, a cube can be turned on the lathe!

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081