Turning Archive 2005

Subject:
Tailstock Drillchuck help needed

Michael Stadulis, in Gloucester County, NJ
>Hi gang, and Happy New Year,

In a recent auction I acquired a box lot from a hardware store w/ about 4 Jacobs chucks. One is threaded 1/2 X 20, and I was hoping that I'd be able to find a threaded #3 MT to screw into it so I can use it. Any ideas of where I can find one, or will I find out that it's cheaper to buy one at Crafts Supplies?

BTW, does anyone need a small chuck for a project? Let me know and I can supply you with one.

-Mike

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081