Turning Archive 2004

Subject:
Thanks for advice, knob in place, table finished!

Randy Todd in Dallas GA
>Well I realize that none of you would be the least excited about a small walnut pull knob for a drawer, but for me this is a first success at the lathe. It took four tries to finish a good knob without tearout or trashing the knob while parting!

The knob is in place on the table and after a few coats of lacquer today it will be ready for Christmas morning!!

Thanks again for the advice,

Randy Todd

Messages In This Thread

Thanks for advice, knob in place, table finished!
Re: Thanks for advice, knob in place, table finish
Re: Thanks for advice, knob in place, table finish
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081