Turning Archive 2004

Subject:
Vacuum Gouge

Stan Campbell
>I recently Purchased the Vacuum Gouge from CleanTurn Tools and I must say I like it alot. I don't have hardly any chips or dust on the floor or on me, it all goes into the Shop Vac. It is a round gouge about 27 inches long with the first 2.5 inches being M2 Steel. Another feature I like is if it gets dull, just rotate it a bit and use another part of the gouge. Being round that gives 2 to 3 inches that is sharpened.

http://www.cleanturn.net/

Stan Campbell
Columbus,OH

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081