Turning Archive 2004

Subject:
Tool Making question?? *LINK*

Ezekiel Holliday
>I'm wanting to make a couple of bent angle tools like Robert Rosand sells. I've already have the 3/16" tool bits and 1/4" square steel.
e and braze th
Here's my question. Should I just cut the end of the 1/4" steel off and the angle tip on? Or, should I have the end milled so that the extra 1/16" of the 1/4" bar is under the cutter?

Zeke

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081