Turning Archive 2004

Subject:
dust collector hose

Dennis Taylor (Akron, Ohio)
>Can someone post a pic or a site that shows some ways of putting up the dust hose behind the lathe?..I have a 1442 and a psi small round around dust collector, I have a hose on it 4 inch, but can't seem to find a way to keep the hose behind the lathe so needless to say it don't get used as often as it should...I have a hood, but it is always in the way, I seen a lot of hoses just sitting there..I was wondering also, can the hose be the flexible vent pipe for a dryer?..tks for help..Dennis

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081