Turning Archive 2004

Subject:
Beall Buff finish

Dennis Taylor (Akron, Ohio)
>I picked up the buff today, and have a question in regards to the finish, sounds like it is intended that you use an oil finish on the turning and then buff..I typically use lacquer, not used oil, and was wondering if it would make any difference in the outcome of the buff?..Dennis

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081