Turning Archive 2004

Subject:
Sanding Hollow Forms

Ezekiel Holliday
>What is your prefered method of sanding hollow forms. I'm curious about a sander mounted on my boring bar. I've got a Jamieson Hollowing System. Most of the forms I've been doing have about a two inch opening. Some opening a slightly smaller.

Thanks,
Zeke

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081