Turning Archive 2004

Subject:
Burl from the AAW Orlando meet *PIC*

TDaniel
>I bought this burl in Orlando. It measures 36" tip to tip. I turned it to a thickness of 3/8". Wings were difficult to turn because I could not use a steady due to the shape. I had to depend on centrifugal force to hold the wings so I could cut them once they were about 3/4" in thickness. I am still working on the finish so I do not know if I will make it sating or gloss but I am thinking satin. Thanks for looking.
TD

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081