Turning Archive 2004

Subject:
Aarrgh.... *PIC*

Mike Schwing from Md.
>You know how when you whittle away at the little nub in the bottom sometimes if you didn't adjust the height for it, the tool will move to the other side and "wrap around" and bang down on the tool rest? Usually no big deal unless you didn't tighten down the tool rest properly. It dropped and what you see is what I got. Haven't had this happen in, well...ever actually! Won't be the last, but probably the last time for this particular reason. Should have drilled the hole a bit deeper to start.

All I had left to do was make it a little thinner and clean up the sides. No biggie.

No comment required!

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081