Turning Archive 2004

Subject:
Toolrest Question

Dan Faux
>Just bought a Vicmarc VL175SH and noticed that the tool rest is out of square by about 3mm..As I am not the greatest authourity on lathes ..will this make any difference or do I just file it square?
thanks

Messages In This Thread

Toolrest Question
Re: Toolrest Question
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081