Turning Archive 2004

Subject:
new lathe *LINK*

sanford chandler
>I need some input on a new lathe. I have two lathe's, neither of which meets my needs (Ridgid and Craftsman). I am seeking input on purchasing a new one. My primary interest is in turning bowls. I talked with Terry Daniels and am sold that the VB36 is top of the line,however, I do not want to spend the amount of money it will take to purchase one. I have looked at the VEGA 2400 and it seemed good for the money but I know nothing more about it's performance.

Any advise or input is appreciated.

Messages In This Thread

new lathe *LINK*
Its in the numbers...
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081