Turning Archive 2004

Subject:
Vic thread

bill hale
>I have been off line for about a week and came back to this.
In my humble opinion Vickmark should have handled this post haste no questions. For the value of the lathe and a dealership the have vastley lost credibality with a host of very verbal turners. I have a Oneway 2436, a Vic 200 and a var Jet 1014.
I do some teaching and have recommended the Vic many times but not again.
In my opinion quality and service go hand in hand. If Vic felt they could not afford to handle this they must be on their way out anyway.

Good turning and be safe
Bill

Messages In This Thread

Vic thread
Re: Vic thread
I have to agree Ron
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081