Turning Archive 2004

Subject:
Jet 1014 question

Don Henthorn
>I am finally turning a little bowl on my Jet 1014 and find that the banjo will not go over the motor. Is this normal? I do have the Vegas motor and controller and will be making the lathe variable speed, like Mark Kauder, in the future, but it may be several months until my house sells and I get moved. I would like to turn a litte as time allows, but the failure of the banjo to go over the motor is a drag (no pun intended) Has anyone else experienced this?

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081