Turning Archive 2004

Subject:
Mr TDaniel

Dustmaker Mike
>On my way to work this morning I was thinking (I know scarry) about what you said last night during the chat. If I understood you correctly you said you had a few shallow gouges you could not sharpen on the Wolverian jig because they were to short. If this is the case why not use a piece of 2x2 drill a hole in the end and cut it to length to make the correct angle to the wheel. I think if you support it in the middle by makeing a raiser block with a "V" cut in the bottom

Messages In This Thread

Mr TDaniel
Fell asleep during that post
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081