Turning Archive 2004

Subject:
Replacement jet 1014 came today and checked out ok

Don Henthorn
>Replacement Jet 1014 came today and checked out OK. will follow Mark Kauder's instructions in installing the treadmill motor. Thanks, Mark. Thought I had downloaded the instructions from the WM site on modifying the control board, but haven't found it yet. Went to Mark's old post and tried the link there but it no longer works. I think I know which part to cut loose. I Hope!!!!!!!

Messages In This Thread

Replacement jet 1014 came today and checked out ok
Re: Replacement jet 1014 came today and checked ou *LINK*
Thanks, John F. That should do it. *NM*
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081