Turning Archive 2004

Subject:
Nova Chucks - Original or Super?

Brian Gray in Sandusky, OH
>I don't spend a lot of time on this side of the forum, but I'll will be spending more and more......sorry if this is a newby question.

I used to do a good amount of turning, and I'm now getting back into it. The biggest obstable that I had previously, was I turned on a piece of junk Grizzly lathe....I have a Nova DVR arriving this week, and I'm excited to get back into the turning groove with adequate machinery....

On my old lathe, I used the original Nova Chuck. Since I'm doing a major upgrade with turning in general, it might be time to upgrade my chuck as well.

I will be doing plenty of bowls, and look forward to some large diameters, as well....if that aids in the advise you might give.

Please tell me if it's worth it to upgrade to the
Super-Nova. Differences?

Thanks in advance.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081