Turning Archive 2004

Subject:
Topic for 6/30 "Goblets"

TDaniel
>A nice project for any lathe, small or big, is a goblet. No expensive tools are required, no expensive wood, but good technique and tool control are essential as well as a good eye for form. In preparation for this topic I would like as many posts as possible including photos, dimensions/proportions, etc. Any comments on types of wood that work best and those that should not be used are also requested.
Thanks all
TD

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081