Turning Archive 2004

Subject:
Oliver Lathe info search *PIC*

Bert Workman
>Hello folks, I've come across an older Ovliver lathe and was wondering if anybody had information on it. My initial searches on the net turned up this photo of a model 167 from 1964. This is very close to what the lathe looks like. The only real difference I can see is that there is a dip/gap/recess in the bed next to the head stock. I assume this is for additional swing for turning a platter or such. The lathe I looked at may be a bit longer as well.

Any body have a clue about its worth?

Thanks,

Bert Workman

Messages In This Thread

Oliver Lathe info search *PIC*
Re: Oliver Lathe info search
Where in CAT country, John? *NM*
Re: Bed Gap
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081