Turning Archive 2004

Subject:
McNaughton curved blades

Gary Bills in NC
>I sometimes wish I had a McNaughton curved blade that was bent at a slightly different curve then what is available from McNaughton. Has anyone bent a slightly curved blade to a tighter curve? I could use one that would be "inbetween" the curves available.
Would I have to heat it?

Messages In This Thread

McNaughton curved blades
Re: McNaughton curved blades
Re: McNaughton curved blades
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081