Turning Archive 2004

Subject:
Thanks for the Carver info

Mark Mandell - Gone Round In Jersey
>Thanks again for the responses to my search for power carving info. Refurbed by 40y/o Foredom CC, put this little $50 recipro unit on the shaft, and tried out the thingy with the El Cheapo cutters included on a piece on the lathe. After I reforge some chisels into the shapes I use, this will do for a start on adding tactile areas to some turnings. I'm not, of course, ruling out a TurboCarver at some point . . .

Mark
-2=mail

Messages In This Thread

Thanks for the Carver info
Re: Thanks for the Carver info *LINK*
Re: Carving
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081