Turning Archive 2004

Subject:
Spindle Turning Question

Tom Colligan, Peoria
>When you're starting a spindle type project where there will be some coves, etc. do you always, for example, use a parting tool to establish the depth of each cove, etc.? (I'm very new to turning but in a few months I'd like to take on making the 'spindle' for a tilt top tea table and wonder if it's automatic that you establish the depth of each profile first.) Tia,

Messages In This Thread

Spindle Turning Question
Re: Spindle Turning Question
Re: Spindle Turning Question *LINK*
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081