Turning Archive 2004

Subject:
Segmented Turning

Joe P
>I'm just getting started with segmented turning and I was wondering if I should use an Incra 2000 Miter gauge to cut the segments on the table saw or should I use my miter saw?? Also, I want to start off doing a simple solid bowl, how are you folks doing your clamp ups.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081