Turning Archive 2004

Subject:
Smart Miter and Segments

Stuart Johnson
>Are any of you using the SmartMiter for cutting segments? If so, how do you control the measurment of the cuts? I'm just not getting what I consider close enough. For example at 15 degrees I'll get 1/16 to 1/8 gap. I can compensate by setting it at about 15 1/2 degrees but this is hit and miss and isn't using the miter gauge properly. I've only been using it since December but I think I have it set up correctly.

Messages In This Thread

Smart Miter and Segments
Re: Smart Miter and Segments *LINK*
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081