Turning Archive 2004

Subject:
Angle drill mod

TDaniel
>I was at Dixie Industrial Service today in Chattanooga, TN. While there I asked about the problem with the Sioux and Milwaukee angle drills that we all use for sanding. If anyone has one of these that is giving trouble you might want to send it to Dixie and specify that all bearings be changed to sealed bearings. The factory bearings are shielded only. The sealed bearings cost about $3 more each and there are 6 of them. You can contact them at:
423 698 8063.
TD

Messages In This Thread

Angle drill mod
What Problems? *NM*
Re: What Problems?
Ok, Thanks *NM*
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081