Turning Archive 2004

Subject:
centering a bowl with a vacuum chuck

Tom Blahnik
>I have my vacuum chuck set up for my lathe but have a hard time perfectly centering the bowls on the chuck even with a center point of reference for the tail stock. Is there a jig or method to centering your work on the chuck?

Thanks, Tom

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081