Turning Archive 2008

Subject:
Need help. And I may beed more.

henthorn
>I got my lathe table set up today. I had hoped to build a new one a little better than the old and a little more useful, but that isn't going to happen for a while.

I also got the lathe out of the box and on the table. I was sure panting after that as I still get breathless after very minimal effort. I started hooking it up and couldn't find the picture I had made of the hook up. I think L and N are the power terminals but I am not positive.

I may have fried the controller but am hoping that it was just a loose terminal. I sure am not functioning like I used to, but at last I am functioning......I think.

Glad I have a place where I can spout off once in while.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081