Turning Archive 2008

Subject:
Vacuum Chuck.....

Wally Dickerman in Arizona
>I'm planning on a vacuum chuck for my new lathe. Does anyone have any experience with the Holdfast vacuum chuck system? It hooks up to a shop air compressor. Since I recently got a new compressor that makes about half as much noise as my old one did, I'm wondering if that might be a good way to go.

Wally

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081