Turning Archive 2008

Subject:
LATHE ALLIGNMENT OR NOT *PIC*

Bill Hale / The Wood Spinner
>I just came across something I had never thought about. There have been a number of threads on off center problems and they always blame the lathe. Well here is a pic that shows another possible cause. I pulled the center pin out to show the problem.

Good turning and be safe
Bill in CG, AZ.

Messages In This Thread

LATHE ALLIGNMENT OR NOT *PIC*
Re: LATHE ALLIGNMENT OR NOT
Re: LATHE ALLIGNMENT OR NOT
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081