Turning Archive 2008

Subject:
Thompson Detail Gouge

Cory in MN
>I've seen some posts in the past few months mentioning Thompson Lathe Tool's detail gouge. After visiting Mr. Thompson's web site, I'm curious if those glowing recommendations were for the standard detail gouge, or shallow detail gouge. I'm certain they are both very good, but am curous what everyone is using.

Thanks,
Cory in MN

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081