Turning Archive 2008

Subject:
Sanding Speeds *PIC*

MikefromTn.
>I have recently been working with some hard as concrete Maple. I normaly don't sand any faster than 1500rpm or so as this seems to get the job done. However at that speed, this Maple was taking too much time so I kicked it up to about 2300 or so. Much better if I watch the heat. Am I way off base with this? What's common with everybody else? Also, have I missed the abrasive guest on the Wed. chat. Ellis said something a few weeks ago about having a rep on.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081