Turning Archive 2008

Subject:
Sharening tools using the lathe

Jeff L
>May be a dumb question but can one use the lathe to sharpen ones tools? Can a grindng wheel or somethng be attached to the chuck? I have not seen any discussion of this. If it can be done, what is the best method? What grit would be the best?

Thanks

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081