Turning Archive 2008

Subject:
Hunter Cutters *PIC*

Mark Mandell - Gone Round In Jersey
>Finally got my Hunter cutters mounted for my boring bars. This pic of the straight holder which is made from 9/16 O-1 drill rod. The 3/4" step-down is cut to .375 which fits the sockets drilled in my 1" and 3/4" boring bars. The bars are drilled off center to give maximum meat for the set screws. The cutter mounts were milled and then the cutters are bedded on a double layer of aluminum tape.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081