Turning Archive 2008

Subject:
PM 3520 Tail Stock Pin - Help

Jerry Hall
>The little pin that keys into the tail stock shaft keeps slipping down. I tap it back in, but now it comes out at the start of every new project. Any ideas? Replace it with a new one that is a press fit? Epoxy it in? Or??? Don't want to make it worse with a dumb fix.

Thanks for your help.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081