Turning Archive 2008

Subject:
Is anybody using the Worksharp on lathe tools?

Mark in B'ham, AL
>I have tried sharpening my gouges with the slotted wheel. I am only using the course grit. I got some used tools in a box of stuff from my father that need a good bit of sharpening and reshaping.

Is anybody else using the WS3000? Are you progressing through grits? Do I need another slotted wheel?

Thanks, Mark

Messages In This Thread

Is anybody using the Worksharp on lathe tools?
So, I'll take that as a "no" then. *NM*
Re: Is anybody using the Worksharp on lathe tools?
Worksharp review *LINK*
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081