Turning Archive 2007

Subject:
"Flattening the bottom of boxes?

JL
>I've been having fits with the inside bottoms of my boxes. I'd like for them to be fairly flat. I've been using a flat scraper - but I get the occasional "dig" - probably because they are fairly deep.

Any other suggestions on how to proceed? TIA.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081