Turning Archive 2007

Subject:
Lathe Hight

Lester Gillett/Independence Mo
>After turning some pens to day my back is sore from bending over. How
have you raised your lathe up to a good hight? Would like to see some
photos of how you did it. Was thinking of making 4 small blocks and
setting each leg on them. Not sure if it will make the lathe stable.

Lester

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081