Turning Archive 2007

Subject:
Wolverine sharpening jig

Brian
>I'm setting up my jig and realized too late that the instructions state: "The base must be not less than 1/2" from the front of the mounting board."

Before I go resetting my grinder on the spacer board, I thought I would inquire if it really "must" be less than 1/2". I'm anticipating the answer but can't fathom why it would be an issue with the operation of the jig.

These directions are poorly written. They are grammatically ok, but just don't bring you from beginning to completion in a direct line. Oh well.

Thanks

Messages In This Thread

Wolverine sharpening jig
Re: Wolverine sharpening jig
Re: Wolverine sharpening jig
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081