Turning Archive 2007

Subject:
Vicmarc 300

gtw
>Finally got the lathe wired up today after moving, however when I turned on the VFD 2 little square red lights lit up and when I shut down the code LU came up.

Is there anyone out there in Vicmarc land that knows what this means?

Lathe runs both forward and reverse but the VFD makes a funny noise when I turn it off, don't want to run it in case of problems.

Any ideas gratefully received, Trevor

Messages In This Thread

Vicmarc 300
Re: Vicmarc 300
Re: Vicmarc 300
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081