Turning Archive 2007

Subject:
Red Gum Burl HF *PIC*

Andy Blackwell
>This is a small (4"s h, 2-3/4" w) hollow form made from AUS burl. I finish these with high gloss lacquer. That presents a problem for me. I can not seem to get rid of the reflections when trying to photograph this type finish. I am less than a novice when it comes to photography so have lots to learn. Any assistance and advise would be appreciated. I have read everything I can find on this but to no avail. I don't have a problem with less reflective surface finishes. I think that I will have to find a hands on tutor.

Comments are always appreciated.

Thanks,

Andy

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081