Turning Archive 2007

Subject:
Lamp auger size?

Robert Henderson
>I have a Jet JML1014 mini lathe that has a 3/8" hole
through the tail stock (according to the specification,
I havn't measured it).

Do I need to buy a 3/8" lamp auger
or should I get a 5/16" lamp auger
so I have a little clearance?

Ditto the hollow center?

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081