Turning Archive 2007

Subject:
BREAK TIME

Bill Hale / The Wood Spinner
>Well I just blew up a nice Juniper burl hollow form. All done but the final scrape inside and sanding. It had nice bark inclusions and a full bark rim, about 12 " Dia and 4 " deep. Just not that tough of a piece to turn. Dennis Sturt arm brace with a small scraper in an offset tip. It grabed, swirled the tool---BOOM.

Oh well I guess this is what keeps me on my toes and tells me to slow down.

Good turning to all, slow down and be safe

Bill in Casa Grande, AZ

Messages In This Thread

BREAK TIME
Re: BREAK TIME
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081