Turning Archive 2007

Subject:
Holders for my Hunter Inserts *PIC*

Eddie Pacheco, San Jose, Ca.
>I drew up some holders for my Hunter inserts to fit on my Termite tool handle. My machinist buddy finished these today and I'm giddy to use them. So giddy that we modified some socket flat head screws to hold the inserts. The straight inserts are of 416 stainless steel that he heat treated (G Job) to 38-40Rc. The bent ones are just cold rolled steel bent using a torch and cheater bar of sorts. The photo also shows the original Termite tool. I'm multi taking between internet, cooking some chicken, and Thursday Night Football. Ok, gotta go now.
Take care and don't fight!

Messages In This Thread

Holders for my Hunter Inserts *PIC*
Re: Holders for my Hunter Inserts
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081