Turning Archive 2007

Subject:
Sharpening a large bowl gouge

Jim Rutten
>I just got a Crown PM bowl gouge 1/2 inch. I have a six inch grinder and am attempting to sharpen this gouge using my Wolverine. It is fine on the outboard side of the wheel but runs into the motor on the inboard side. I get the whole side bevel sharpened on the outboard side but only 3/4 of the side bevel sharpened on the side towards the motor. Am I doing something wrong? Anyone else have this problem? If so what did you do to solve it. Thanks for your replies.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081