Turning Archive 2007

Subject:
New High Speed Piercing Tool...

Wally Dickerman in Arizona
>Just finished my first piece using my new 400,000 RPM piercing and texturing tool. A small, open bowl with a design on one side. A bit crude but I'm happy with it. There is a definite learning curve here but I learned quite a bit on this one. I'd been practicing on a thin flat piece of wood. The curved surface on a small bowl is more difficult as I knew it would be.

71 years after my first lathe and I'm still having fun!!!

Wally

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081