Turning Archive 2007

Subject:
PM 3520 live center: Will other makes fit?

Aage Rendalen
>John, I got out the live center pin and realized how right you were about the small opening through the live center. The lamp auger I bought two years ago and have never used, was too big. In so much as the opening through the tail stock is wide enough, I would imagine that I could just go ahead and buy a live center from another manufacturer and use it in my Powermatic. Right?

Messages In This Thread

PM 3520 live center: Will other makes fit?
Re: PM 3520 live center: Will other makes fit?
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081