Turning Archive 2007

Subject:
Tool for HF

Richard Jones
>Looking to start turning a few hollow forms. Am wondering about a good “starter” tool. Am looking at the Sorby with the bent neck. IF this is suitable for 4-6” dia pieces, would I also get additional cutters? If so, which ones?

Many thanks from the suburbs of beautiful, downtown Deatonville, VA…………………

Rich

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081