Turning Archive 2007

Subject:
Getting under deep shoulders of HFs

Aage Rendalen
>I recently bought the Jamison system, and I'm having trouble getting under the shoulders of Southwestern type HFs. The back gate imposes limits on the angle of the boring bar, and for deep shoulders I've had to pull out my manual Kelton hooks to get in as deep as I want.

I've looked at the end of the boring bar cut at 45 degrees but it does not seem very promising to me.

How do the rest of you deal with these deep-shouldered vessels?

Messages In This Thread

Getting under deep shoulders of HFs
Don Pencil armbrace with curved shaft
Re: Don Pencil armbrace with curved shaft
yes, 5 armbraces
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081