Turning Archive 2007

Subject:
I coulda been a contenda

Ron in Drums PA
>I was talking to Andy DiPietro yesterday about one of my screw-ups. This almost finished as a hollow form. I had the form vacuum chucked and I was cleaning up the bottom when we had a power outage. I bet you can figure what happen next.

The bottom didn't really suffer much damage and I had it on one of my benches (I think it use to be a table saw once. I was trying to figure out how remount it and make a new top.

Bu the time I figured how to do it, the form moved enough to make it even more difficult. All I needed to do was a little sanding to finish it off.

It measures about 4.25" high and about 6.5" wide

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081