Turning Archive 2007

Subject:
Cover for PM 3520?

david
>Our club purchased a PM 3520 for demos. Meetings are normally held at our local Woodcraft store, and the owner has generously kept the lathe in storage for us, hauling it out for meetings every other month. The lathe ways is getting pretty corroded and the entire unit could use some attention, some lubrication and perhaps even a cover. Is there a cover made specifically to cover this unit? Faced with potential rust, has anyone adapted another type of cover for this lathe? TIA

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081